It almost looks like a dead forum here!

I had the same problem

Klic this link:

http://www.raspyfi.com/forum/r.....ot/page-2/

And look at he post of Oboema of 27 september

You just hace to replace the three .elf files.

Just read this and you will understand my frustrating:

http://www.raspyfi.com/forum/r.....nt-boot-1/

OR:

Go to this page and install Volumio

http://volumio.org/

It is nice software but I am a little bit desperate now to add my files from a NAS
Tried everything but won't work

VERY NICE SOFTWARE BUT YOU GET PROBLEMS WITH THE MOST EASIEST THINGS
JUST ADDING A NAS DON'T WORK????

Maybe you can help me

I can't get anything to happen after writing the image to SD card and attempting to boot. I've followed the simple instructions and done it three times but stil nothing happens. If I try to go to http://raspyfi/ I get nothing, and there is nothing displayed on my screen via HDMI (should I even expect anything?).

To test the hardware I just put Raspbian on the card instead and booted up and that works fine - output on the screen and ethernet connection all working ok, so I don't think I have any hardware issues. I don't have a DAC or external drive attached, only mouse, keyboard, HDMI and 3.5mm audio.

Any ideas?